Indeed. Patches have up to 48 blocks, routing is more flexible than ever and amp channels (for most Agoura amps) are accessible within a single switch in a single block. I cannot fathom the need for more than one preset per song.
Line 6 Helix Stadium
- Thread starter Lysander
- Start date
Indeed. Patches have up to 48 blocks, routing is more flexible than ever and amp channels (for most Agoura amps) are accessible within a single switch in a single block. I cannot fathom the need for more than one preset per song.
Thank you - I hadn’t understood that correctly and hopefully that will help here :)
molul
Roadie
- Messages
- 914
In OG Helix I have 3 multi-preset songs because of DSP limit. It was easy to configure them so switching to next preset is unnoticeable (I only need a 1s silence in the song).
Normally I'm perfectly fine using snapshots in the same preset.
GTR37
Rock Star
- Messages
- 4,446
I don’t have an issue but I think that also will depend on expectations if say someone wants an Agoura Princess
Revv red , JCM800 with poly shifts Can they do that in one preset?
Sascha Franck
Rock Star
- Messages
- 9,851
Basically me neither, but I can still see how you might want to dedicate a preset to one sound type, say cleans, and then use another preset for dirt. Kitchen sink presets, while I like them, get tough to keep track of sometimes.
paisleywookiee
Rock Star
- Messages
- 8,380
molul
Roadie
- Messages
- 914
I really hope that, despite Agoura amps are more DSP intensive, the Stadium DSP allows for at least a couple of them plus some other DSP intensive effects.
Probably not completely, but that should be easy to work around. You could stand in either the HX Revv Red or the Line 6 Oblivion and greatly reduce the amount of DSP being hit. From what I've seen, there's enough DSP - even at the currently moderate levels of optimization - to run Poly Pitch on the 1/2 lane, and then move those amps to the 3/4 lane below.
Mikael Dez
Rock Star
- Messages
- 2,897
Mods can we get the word dollars to auto-correct to Tim Bucks?
ian_dissonance
Shredder
- Messages
- 1,495
If it doesn’t fit you make compromises for live use. If you’re using all three amps simultaneously you’re probably just sending a bunch of stereo garbage out to FOH anyways, lol.
GTR37
Rock Star
- Messages
- 4,446
They are not implementing that same use half your DSP to do gapless switching this time DI has said that they are looking into other ways to do it not so taxing in the CPU so it is conceivable that OG Helix will have quicker switching on launch
GTR37
Rock Star
- Messages
- 4,446
Not simultaneously but can you actually have 3 Agoura amps in a single preset we don’t know that
Fractal has channels so they can use 4 amps per preset if you wanted to obviously 1 at a time but the capabilities are there
That's fine, but that's only to have a buffet of certain types of tones on tap in the studio. You could also have your preferred cleans and dirt saved as favorites for quick recall too.
If we're talking about live, time-sensitive use, you can have clean/dirt/lead/whatever live in a single preset with snapshots. Snapshots/scribble strips help make it easier to keep track of, and Showcase will make it even easier for live use.
Always going to be edge use cases, and "needing" 3 Agoura amps specifically live in a song is one of 'em.
- Messages
- 1,378
Preset switching time is always the last thing that's done. Not sure if it'll get noticeably better for 1.1 (yes, currently slower than Helix), but it's definitely on our docket to continuously improve after launch.
- Messages
- 2,362
Is this latency?
- Messages
- 1,378
No. Full throughput latency is the audio delay through the system, from A/D conversion to D/A conversion. USB latency is the audio delay through a computer. We're still optimizing both of those as well.
- Messages
- 2,362
So you were talking about switching from one preset to another. There’s some lag there it’s not instantaneous and it’s worse leg than the original helix.?
