Fender Tone Master Pro: Episode IV - A New Hope

[metropolis_4]

I think at this point the QC is the only big modeler without gapless presets

 

[Jarick]

I think at this point the QC is the only big modeler without gapless presets

Doesn’t Stadium have a pretty big gap? At least in normal mode (not sure if it has the same gapless option).

 

[metropolis_4]

Doesn’t Stadium have a pretty big gap? At least in normal mode (not sure if it has the same gapless option).

To be honest, I haven’t been following Stadium so I’m not sure. I guess I assumed since Helix does it probably does as well?

 

[Jarick]

To be honest, I haven’t been following Stadium so I’m not sure. I guess I assumed since Helix does it probably does as well?

In one of the demo videos from WT there was a pretty noticeable gap. That may have been due to a pre release firmware though. But they were even laughing and calling it out.

 

[JiveTurkey]

There is a preset gap currently. Still early days.

 

[metropolis_4]

There is a preset gap currently. Still early days.

That’s really surprising…

 

[Tritium3H]

Perhaps some Fractal power user can correct me, if I am wrong, but I believe there are caveats/constraints in the Fractal AX3/FM9/FM3 ecosystem, if you “enable” gapless preset switching.

In other words, I believe there is some trade-offs, in which a full-blown “everything and the kitchen sink” grid/preset requires some forethought and planning if you want to achieve a gapless preset switch, while still maintaining delay and reverb spillover.

 

[Frodebro]

Perhaps some Fractal power user can correct me, if I am wrong, but I believe there are caveats/constraints in the Fractal AX3/FM9/FM3 ecosystem, if you “enable” gapless preset switching.

In other words, I believe there is some trade-offs, in which a full-blown “everything and the kitchen sink” grid/preset requires some forethought and planning if you want to achieve a gapless preset switch, while still maintaining delay and reverb spillover.

I don’t honestly remember what the trade off is, if anything. Maybe a slight CPU hit, but I haven’t noticed any significant performance change.

 

[OrganicZed]

Perhaps some Fractal power user can correct me, if I am wrong, but I believe there are caveats/constraints in the Fractal AX3/FM9/FM3 ecosystem, if you “enable” gapless preset switching.

In other words, I believe there is some trade-offs, in which a full-blown “everything and the kitchen sink” grid/preset requires some forethought and planning if you want to achieve a gapless preset switch, while still maintaining delay and reverb spillover.

It eats about 2% of CPU and you’ll have the best results if your delay and reverb types match in the two presets.