Boss 200 Series Pedals Design Floor ?

Dave Lewis

Shredder
Messages
1,838
I was ready yesterday to build my Boss 200 pedalboard using all of the 200 series pedals .
When It suddenly dawned on me It can’t be done unless they are all laid out side by side or one uses a 8 pedal switching system.
Because of the sloping front angle they can’t be laid above each other 😡
I’m guessing people have probably already noticed this before 😳
1754395703900.jpeg
1754395755593.jpeg

1754395818864.jpeg
 
Last edited:
Pedaltrain makes some lifts that will angle pedals upwards? Might be interesting to see how they sit. If you have a slanted board; you could flip the top row of 200 series pedals around so the switches are at the top? I'd probably just do side by side.
 
Pedaltrain makes some lifts that will angle pedals upwards? Might be interesting to see how they sit. If you have a slanted board; you could flip the top row of 200 series pedals around so the switches are at the top? I'd probably just do side by side.
On any flat or slanted board it’s the same and even flipped you still hit the controls .
I’m a size uk size 8 and bigger feet would be worse.
I thought about using lifts but it angles the sockets on the back down to far.and you would still stomp on the pedal controls in front.
So it’s going to have to be a switcher or a side by side board .
 
On any flat or slanted board it’s the same and even flipped you still hit the controls .
I’m a size uk size 8 and bigger feet would be worse.
I thought about using lifts but it angles the sockets on the back down to far.and you would still stomp on the pedal controls in front.
So it’s going to have to be a switcher or a side by side board .
I think side by side would look the best anyway (y)
 
On any flat or slanted board it’s the same and even flipped you still hit the controls .
I’m a size uk size 8 and bigger feet would be worse.
I thought about using lifts but it angles the sockets on the back down to far.and you would still stomp on the pedal controls in front.
So it’s going to have to be a switcher or a side by side board .

My SDE-3000d is the same shape and it works fine for me on the back row with lifts

IMG_5042.jpeg
 
Back
Top