Line 6 Helix Stadium Talk

[[Nathan]]

Did the firmware update. Probably unrelated but im having a lot of upload problems with captures, they fail to upload for processing.
When it fails to upload it restarts the capture process and it has to reamp the training file. It would be good if it could resume so I dont have to keep waiting while it does the same task over and over again.

 

[dean701]

Did the firmware update. Probably unrelated but im having a lot of upload problems with captures, they fail to upload for processing.
When it fails to upload it restarts the capture process and it has to reamp the training file. It would be good if it could resume so I dont have to keep waiting while it does the same task over and over again.

Are you getting an error code?
Saw someone else getting an error 2603.3 when trying to upload.

 

[[Nathan]]

Are you getting an error code?
Saw someone else getting an error 2603.3 when trying to upload.

Yeah, it’s been alright the last few hours maybe there was issues earlier.

Wasn’t getting good results from my preamp pedal anyway, moved onto something else

 

[Gary_W]

It sounds like the hardware might be replicating the CE-1 impedance. Have you checked your input block? The stock CE-1 will load down your pickups.

I’m not the one asking the question but this is a good point that is interesting - I tend to leave my input block set to ‘first in chain’ so I can take advantage of fuzz volume stuff as best you can in the digital world. I hadn’t considered that other models in the chain (other than fuzz) could have lower virtual input impedance. You’ve just shown me a gap in my knowledge :) Possibly not hugely relevant to me as I’ve never really discovered the love of chorus but I do play with simple chains where there’s sometimes a trem or spring verb early on….. I’ll have a play later.

 

[Gary_W]

Did the firmware update. Probably unrelated but im having a lot of upload problems with captures, they fail to upload for processing.
When it fails to upload it restarts the capture process and it has to reamp the training file. It would be good if it could resume so I dont have to keep waiting while it does the same task over and over again.

I haven’t done one in a while - the release notes for the patch the other day mentions ‘server based optimisations and stability improvements’. I’ve seen many an improvement unintentionally break something else so might be worth pinging them a message just in case?