Wampler Pedalhead

[dronerstone]

@politoleo

How's the impedance mis-matching and output power, e.g. if you're connecting a 4 Ohms cab and an 8 Ohms cab?

Still plenty loud and free of trouble?

That said, will it be able to measure both cabs differently if running stereo?

Seriously, the Pedalhead is in one of the top spots on my (non-existent ) "buy in January 2027" list, since I'm successfully holding back on gear purchases, so far.

 

[politoleo]

@politoleo

How's the impedance mis-matching and output power, e.g. if you're connecting a 4 Ohms cab and an 8 Ohms cab?

Still plenty loud and free of trouble?

That said, will it be able to measure both cabs differently if running stereo?

Seriously, the Pedalhead is in one of the top spots on my (non-existent ) "buy in January 2027" list, since I'm successfully holding back on gear purchases, so far.

It will work just like two of the same tube amp where you use the right tap, so matched and issue free!

Yes it measure each cab indipendently

 

[paisleywookiee]

Can this and the IR Load run mono bridged? Not everyone needs/wants a stereo rig.

 

[politoleo]

Can this and the IR Load run mono bridged? Not everyone needs/wants a stereo rig.

No, no bridge!

You can use it mono and just split the load for twice the mono power!

 

[MTB1973]

Any update regarding availability?

 

[paisleywookiee]

No, no bridge!

You can use it mono and just split the load for twice the mono power!

So mono loop, going to two cabs?

 

[OrganicZed]

I think I'm going to get one when they come out. I can shoot it out against my collection of power amps (Fryette 2/90/2, Fryette PS-2, Seymour Duncan PowerStage 700, and my various QSC models). If this can really deliver on the marketing claims then I'll sell the SD PS700 and that should mostly cover the cost. If it falls short, then I'll return it. That's a pretty low risk proposition.