Achilles
Rock Star
- Messages
- 4,972
I've use this all the time for a couple pre-amp pedals that lack a Presence control.
Set the high PEQ band to 5KHz and the Q for the tightest. Increase the gain by a couple of dB and then strum some chords while sweeping both up and down from the 5KHz point. You'll find the sweet spot somewhere between 4KHz-6KHz.
The tight Q is key cause it'll act like a knife to cut through with some sparkle. A wide Q just makes it sound like you turned the treble way up.
Placement is after the preamp or in the FX loop of an amp before any FX pedals.
Set the high PEQ band to 5KHz and the Q for the tightest. Increase the gain by a couple of dB and then strum some chords while sweeping both up and down from the 5KHz point. You'll find the sweet spot somewhere between 4KHz-6KHz.
The tight Q is key cause it'll act like a knife to cut through with some sparkle. A wide Q just makes it sound like you turned the treble way up.
Placement is after the preamp or in the FX loop of an amp before any FX pedals.
Last edited:
