Sorry for the dumb up front, Uberkab rewire to 8ohm or leave alone?

[CorrosiveMatter]

I am looking at an Ubercab but of course it's 16ohm and the Mark V has no 16ohm out, will it sound bad enough to care? Worth or even possible to rewire it to 8ohm?

 

[laxu]

Mark V should happily run it from the 8 ohm out, but this will cause an impedance mismatch so it might lose a bit of power and feel a bit softer.

16 ohm 4x12 assumes that it is wired in series-parallel with 4x 16 ohm speakers.

This can be rewired in parallel for 4 ohms, so you could use the Mark V 4 ohm output.

 

[Orvillain]

I run my Mark V from the 8 ohm output into my 16 ohm Egnater cab all the time. You'll be fine.

 

[ZEN Amps]

It'll sound just fine and no you can't rewire to 8Ω - Boogie's are run like this all the time.

But if advice from strangers on the internet is not quite enough, Mesa acknowledge it's a non-issue In the manual.

 

[CorrosiveMatter]

I saw it’s fine as far as safe and Boogie manual but saw others bitching about the sound suck.

Thank you all!

 

[Mikael Dez]

I’ll add that I run my Mk V 8ohm into an Orange 16ohm cab and it works just fine

 

[Chocol8]

Yes, run the mismatch or rewire to 4 ohms all in parallel. Running a mismatch WILL impact power, breakup and tone a bit, but not necessarily in a bad way, so try it out and see what you like.

 

[Orvillain]

I saw it’s fine as far as safe and Boogie manual but saw others bitching about the sound suck.

Not something I've noticed at all. It sounds just as good using 8ohm>16ohm, as 16ohm>16ohm.