HX Stomp parameter and snapshot issue

[ragingplatypi]

I’m having an issue on my Stomp where snapshots are changing parameters that shouldn’t be changed.

FS1 is assigned to change the decay, mix and size on the Dynamic Hall Reverb. Snapshot bypass is set to “off” for the Reverb.

FS3 scrolls up my snapshots. The only block with the snapshot bypass set to “on” is the Minotaur which is off on snapshot 1, low gain on snapshot 2, and high gain on snapshot 3.

When I scroll through the snapshots, the parameters on the Dynamic Hall Reverb also change, which I do not want to happen. I even rebuilt the preset to make sure I didn’t accidentally adjust reverb parameters when building the snapshots.

Anyone else experience this or have insight into what I’m doing wrong?

 

[Foxmeister]

Might be an idea to share the preset here...

 

[ragingplatypi]

Might be an idea to share the preset here...

Ok. Might take me a while to get to it, but I’ll do my best.

 

[ragingplatypi]

Might be an idea to share the preset here...

Here's the patch....

https://line6.com/customtone/tone/6115798/

 

[DieSchmalle]

Disengage the Snapshot Control option for each of the 3 reverb parameters in the Bypass/Controller Assign tab.

 

[ragingplatypi]

Disengage the Snapshot Control option for each of the 3 reverb parameters in the Bypass/Controller Assign tab.

Holy crap! I never paged over that far and didn’t realize it was there
Thank you!

 

[James Freeman]

Trivia: Prior to 3.50 there was no way to bypass snapshot control over individual parameter assignments, it was always on.

DieSchmalle wins!

 

[pipelineaudio]

Me neither, and then someone on here showed me and it totally saved my drop tune harmonizer setup so I could use half the number of presets I would have had to otherwise