metropolis_4
Rock Star
- Messages
- 4,173
New idea: satellite board to handle switching and routing for theater stuff. That way my electric board can be smaller and easily used on its own when I’m doing just electric gigs.
Also thinking about just getting a mixer to run all the acoustics through instead of a Stomp. It would be cheaper and simpler. This also lets me bring back my page turner!
On the electric board the signal goes like this:
Chorus Ensemble -> Switchback -> H Monk -> some reverb pedal -> SDE-3000
Switchback Loop 1: Dynacomp -> ge-7 -> SCF -> True Spring
Switchback Loop 2: DOD 250 -> Rattler -> MG
Electric board is Creation Aero 18. Satellite board is 10x12.5
Under the shelf:
And acoustics go to something like this
Or I could use a slightly bigger satellite board (14x12.5) and run the stomp
I’d probably just cut a board and spray it black for the satellite board.
Also thinking about just getting a mixer to run all the acoustics through instead of a Stomp. It would be cheaper and simpler. This also lets me bring back my page turner!
On the electric board the signal goes like this:
Chorus Ensemble -> Switchback -> H Monk -> some reverb pedal -> SDE-3000
Switchback Loop 1: Dynacomp -> ge-7 -> SCF -> True Spring
Switchback Loop 2: DOD 250 -> Rattler -> MG
Electric board is Creation Aero 18. Satellite board is 10x12.5
Under the shelf:
And acoustics go to something like this
Or I could use a slightly bigger satellite board (14x12.5) and run the stomp
I’d probably just cut a board and spray it black for the satellite board.
