Fractal Audio Systems AM4 - Amp Modeler

[EOengineer]

Yep, expert mode in the amp block (page right a few times… should be after the output compressor page but before the speaker cabs page)

Of course, thank you.

 

[paisleywookiee]

Either the modeling is so much better than the one in the Ax2 or Ax8.

It IS way better than those. I wasn't really sold on modelers until the current gen, in like Cygna or whatever.

Hmmm. I’m gonna live with this for a bit longer but I might just ditch my UA pedals and get an Axe3 or maybe wait for next gen.

Yeah I'm doing one of these on my board, and then I'll get a next gen big boy when it comes out.

 

[iaresee]

They probably shag hamsters.

 

[Orvillain]

 

[EOengineer]

 

[BROCKSTAR]

Damn... I see I'm back on the wrong side of the internet again.

 

[bucephalus]

Yeah, but your kids are going to love it.

 

[Los-D]

Latency is the new aliasing

Don’t forget about device boot up times.

(BTW the AM4 is like 6 seconds )

 

[BROCKSTAR]

AM4 V1.02 Beta 3 Release

AM4 V1.02 Beta 3 Release firmware is available here: AM4 V1.02 Beta 3 The supporting AM4-Edit can be downloaded here: AM4-Edit V1.00.01

forum.fractalaudio.com

1.02 Beta 3 is the same as beta 2 with one exception:
Fixed a USB input level mismatch that affected re-amping workflows using recorded DI signals.

 

[Mongillo19]

Anyone else notice that in the advanced parameters, when you change an amp it doesn't always automatically link to the correct cab in the dynacab section? It defaults to a 1x8 5F1 Tweed curve. Bug or user error?

I'm on 1.02 beta 2

 

[BROCKSTAR]

Anyone else notice that in the advanced parameters, when you change an amp it doesn't always automatically link to the correct cab in the dynacab section? It defaults to a 1x8 5F1 Tweed curve. Bug or user error?

I'm on 1.02 beta 2

Do you have the dynamatch option turned on under expert edit and cabinet tab?

 

[Mongillo19]

Do you have the dynamatch option turned on under expert edit and cabinet tab?

I do!