Stadium 1/4" output bug?

Messages
523
When I try to route my preset output to the 1/4" outputs, even with the output volume to that output on maximum, it sounds thin, tinny, and exceptionally quiet. I've gone to global settings and switched the level away from line and back again, no dice. I switched to using the effects send and that works fine. Something wrong with the 1/4" outputs?
 
When I try to route my preset output to the 1/4" outputs, even with the output volume to that output on maximum, it sounds thin, tinny, and exceptionally quiet. I've gone to global settings and switched the level away from line and back again, no dice. I switched to using the effects send and that works fine. Something wrong with the 1/4" outputs?
Hey Karl. Does it always sound like this or if you switch away to say an empty preset and then back to it does it sound like you'd expect?
 
I don't have this. There is a volume issue Frank acknowledged that is being worked on? The 1/4" feeds my amp return or FR12 with plenty of output?
 
Hey Karl. Does it always sound like this or if you switch away to say an empty preset and then back to it does it sound like you'd expect?
Magically started working again. Not sure what I did to make it happen. I tried toggling the mic/line level on the 1/4" outs, nothing. Tried navigating away from the preset and back, nothing. Went to a meeting and came back to it. Works. I'd tried different cables and everything. Same cable out from the send worked. Plugged it into the 1/4" output, didn't work.
 
Magically started working again. Not sure what I did to make it happen. I tried toggling the mic/line level on the 1/4" outs, nothing. Tried navigating away from the preset and back, nothing. Went to a meeting and came back to it. Works. I'd tried different cables and everything. Same cable out from the send worked. Plugged it into the 1/4" output, didn't work.
Which output? If you're only using one 1/4" output, make sure it's the L(MONO) out.
 
Which output? If you're only using one 1/4" output, make sure it's the L(MONO) out.
It was the left 1/4".

I had the left 1/4" and Send 1 both plugged into separate channels of my wedge, and the XLRs into my interface. I tried switching between them by switching the output at then end of the signal chain. The 1/4" out sounded horrible for the whole session of this. Went to a meeting, came back and tried again. When I switched to 1/4" it was fine, just like the other outs.
 
Back
Top